However, when the deposition time is increased to 25 min (this website Figure 5c), the NWs on the surface are no longer uniform in width and height. They exhibit two kinds of morphological changes. One is that some NWs begin to break and the fragments shrink

into wider and higher elongated islands or 3D islands, leaving a narrow trough on the surface, as indicated by the label ‘A’. The other is that some NWs begin to dissolve and become thinner, with atoms diffusing to the nearby large islands, as indicated by the label ‘B’. This phenomenon is more obvious when the deposition time is increased to 50 min, as shown by Figure 5d. In addition, at the deposition time of 50 min, the 3D islands also become uneven in size. Figure 5 shows that with the continuous increase of deposition time, there is a trend for the NWs to evolve into large 3D islands, indicating that the NWs AC220 are a metastable silicide phase. Figure 5 The influence of deposition time on the growth of NWs. Series of STM images (1,000 × 1,000 nm2) of the manganese silicide

NWs and islands grown on the Si(110) surfaces at different durations. (a) 5, (b) 10, (c) 25, and (d) 50 min. The deposition rate and growth temperature were kept at approximately 0.2 ML min−1 and 550°C, respectively. Table 2 Average dimensions and number density of the NWs and 3D islands grown at different deposition Nirogacestat supplier times Deposition time (min) Length of NWs (nm) Width of NWs (nm) Height of NWs (nm) Density of NWs (number/μm2) Size of 3D islands (nm) Height of 3D islands (nm) Density of 3D islands (number/μm2) 5 176.3 18.9 2.9 31 18.0 5.2 49 10 271.5 17.2 3.5 21 24.7 7.2 46 25 281.2 16.9 4.2 25 27.0 7.3 65 50 261.4 16.5 5.1 20 35.9 10.3 70 The growth temperature

and deposition rate for each deposition were kept at 550°C and 0.2 ML/min, respectively. Tenofovir As suggested in our previous studies, the formation mechanism of the Mn silicide NWs can be attributed to the anisotropic lattice mismatch between the Mn silicide and the Si(110) substrate [20, 21]. In the width direction of NWs (i.e., Si[001] direction), the lattice mismatch has a relatively large value, and the adatoms are not easily attached to the two long edges of the NWs because of the high strain energy, leading to the limited growth along this direction. However, with extension of deposition time, more Mn atoms are supplied, and this will introduce dislocations in the NWs [9, 27, 28], resulting in the fragmentation of NWs and, finally, the reduction in their lengths. Meanwhile, the dislocations can relax the high strain along the width direction of NWs and thus make the adatoms attach to the wire edges more easily, leading to the increase in the wire width and height. The ‘A’-type change of the NWs shown in Figure 5c,d can be considered as a result induced by the dislocations. On the other hand, the appearance of ‘B’-type change of the NWs at a deposition time of 25 min (Figure 5c) indicates that the growth of NWs at this stage undergoes Ostwald ripening.